Using the "broken" Epilog

From Mod Lab
Revision as of 22:59, 5 January 2015 by Janick Bergeron (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

The Epilog Laser Cutter is current experiencing technical difficulties: it is impossible to position the laser at a specific location and the gantry resets itself as if it were located in its recess. It is still possible to use it but in a limited way.

  1. Focus the laser by raising/lowering the bed.
  2. Locate the three pencil line on the left side of the gantry recess.
  3. Manually position the laser pointer on the farthest line. Laser Location.jpg
  4. Press "Go" and let the laser reset itself. It will position itself near the edge of the recess.
  5. Put your material in the upper-left corner of the bed.
  6. Position your design at the top, and 3/4" from the left side of your canvas
  7. Make sure your design is less than 11" high
  8. Print without centering No Center.jpg
  9. Press "Go"